![]() Where _n_ is the version number for the old partĬopy all files for new part from the modified parts folder created fzz file to be edited to this new folder. To replace this part in an existing fzz file that uses it:Ĭreate a new folder to hold the modified Fritzing board file.Ĭopy the. ![]() fzpzįritzing Hack 2: Replace a bad part with a better part without affecting the routing. Hange the remaining entries and verify with Inkscape.Īdd all the files to a new zip file and rename to. This example shows the new part being changed back to the old bigger values. fzp file using notepad++ and increase the filenames by 1 to correct the file names referenced insideĮdit the _pcb.svg file and manually adjust the size of the pads (change radius and stroke width)Ĭhange one entry under the "copper0 group", change the values of r="xx" and stroke-width="xx" for a " ![]() To create a new unique part name, increase the filenames by 1 (xxxx_2_pcb.svg - xxxx_3_pcb.svg)Įdit. To detect this issue, run a DRC check with DRC Settings to "Professional" 0.01 If any issues pop up, fix them.įritzing Hack 1 : Fix issues with an existing part:Ĭreate a new folder to hold the part being editedĮxport the original part to this folder, rename the file from. ![]() When laying traces between pads, the traces do not have soldermask between traces and pads, solder bridges can occur between the sides of a trace and adjacent pads. The PicoEnigma boards were hard to solder because the part footprint for the Arduino Mega has an error, the pads are too large. ![]()
0 Comments
Leave a Reply. |